Download FLUKE PM PM PM PM 2X2MV,MHZ OSCILLOSOPE SM service manual & repair info for electronics experts. Re: Fluke PM manual needed (MHz scope) The service manual for Fluke / Philips PM PM PM PM can be found. PM ). Deflection Manual positioning: Horizontal, Vertical, Both . Web access: com.

Author: Kajizil Meztile
Country: Belgium
Language: English (Spanish)
Genre: Music
Published (Last): 28 September 2012
Pages: 291
PDF File Size: 4.3 Mb
ePub File Size: 20.75 Mb
ISBN: 536-7-56630-884-2
Downloads: 54717
Price: Free* [*Free Regsitration Required]
Uploader: Keshura

However, many of the standard electronic components can be obtained from other local suppliers.

Put CH1 in 0. Page Set CH1 to 0. Page The oscilloscope must be capable of displaying signal amplitudes that are larger than the screen. Some of these voltages remain some time after disconnecting the instrument from the mains. This manual also for: Signal Delay Note 3: The driver transistors are V and V Apparatus should be properly grounded through the protective ground conductor of the power cord.

For installation, reverse the sequence. The common mode rejection ratio CMRR is a measure of susceptibility to common mode signals. For this reason, in date certification may not be available for each lot. Ask seller a question. The following voltages are allowed: This susceptibility is verified in this test.

Some of these voltages remain some time after disconnecting the unit from the mains. Here, the accuracy of this range is checked. A good knowledge of the circuitry of the oscilloscope is necessary to take advantage of these tests.


Therefore, it is recommended to wait at least five minutes after having disconnected the unit from the mains, before removing the unit. The output circuits are protected against overload by the under voltage protection. The digital multimeter and oscilloscope are not required for this test. Manual calibration data are protected by a keyword and a seal and must be changed by qualified personnel only. There is mmanual certain instability in the starting point, the so called jitter, of the DTB.

Carefully unsolder the soldering tags of a semi-conductor mnaual after the other. The HF section for frequencies above 5 kHz. The Auctioneer reserves the right to reject any registration at its sole discretion.

Main Time Base Description. The amplifier is located at the small printed circuit board at the CRT socket.

Fluke PM3084 Analog Oscilloscope

It is also possible that the rotor makes no contact. By using our services, you agree to our use flule cookies. What I was thinking about, was if he in some way measured on mains live net for some reason. Over and under-voltage protection To protect the oscilloscope circuitry against over-voltage and the supply circuits against overload, the power supply is provided with a protection circuit. Send a copy to my email address. This eliminates calibration inaccuracies manusl to temperature changes.


Fluke PM Analog Oscilloscope | eBay

Comments to this Manuals Your Name. Page of Go. Best regards PAF IF you are sure there’s nothing wrong on the primary, check for shorted diodes and caps on the secondary side of the switching transformer. In this test, the values of frequency and voltage are checked. For the best chance of winning, increase your maximum bid.

Fluke PM3082 Service Manual

Price The price payable manuao the Buiyer for the purchase of the lots secured shall be the sale price, being the highest bid and accepted by the Auctioneer in accordance with conditionplus the maanual premium and any other associated costs if any and VAT applicable at the prevailing rate 6: Page The trigger sensitivity depends on the amplitude and frequency of the trigger signal.

Just primary shorts has the power to do this, in my opinion based on hundreds of smps repairs. Rough handling or scratching can cause the CRT to implode. On Sun, 13 Jun