BreezeMAX Extreme is part of the carrier-class, field proven BreezeMAX product family and is the first wireless broadband solution to bring WiMAX 16e. BreezeMAX® Extreme WiMAX™ 16e pioneer for the license-exempt market WiMAX 16e for the License-exempt Market Main Features and Highlights. BreezeMAX Extreme is part of the carrier-class, field-proven BreezeMAX product family and brings WiMAX 16e technology to the 5 GHz license-exempt.
|Published (Last):||15 June 2018|
|PDF File Size:||8.70 Mb|
|ePub File Size:||12.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
Such cases might occur when using limited license CPEs and the total number of services defined for such a CPE is above the licensed value. Upgrade to Release 1. The information is not submitted through the TR protocol.
Upon successful completion the unit set automatically “run from shadow” and performs reset 55000. When operating with DHCP option 66 and 67, the CPE might not receive an IP if option 67 is not used only 66 or if the option 67 xml file is not at the specified location.
There is no issue observed with Ping messages of brezemax up to 14K bytes.
BreezeMAX Extreme | WiMAX technology 5 GHz license-exempt solution
Upgrade also the CPE to Release 1. For details on the required changes, please refer to the application note: Each manual covers all relevant topics associated with the respective equipment, including: Network entry timeout prevent s full band scan in universal CC, thus workaround brewzemax needed to set only one BW to scan.
Base Station ID configured in each channel must be unique in the entire network. When using Optimized Video service, it is recommended not to use DSCP values of 1, 8 and 9 for uplink data traffic other than video.
BreezeMAX® Extreme 5000
Multi-host support behind a single CPE might not work. NE failure when provisioning a capacity limit CPE model with brefzemax sum exceeding the capacity limit.
This is mainly since IP address The value may range between 1. Cable to mains is NOT included and should be ordered separately. To refrain from unexpected network behavior it is recommended to set parameters to match the capabilities of the target downgrade version e. The material contained herein is proprietary, privileged, and confidential. Recovery actions beeezemax case BTS was upgraded to 1.
As part of these changes, several additional configuration options are available, such as: When BTS is operating with Release 1. When connection with AAA is reestablished the entire cell will be authenticated again automatic de-registration of all CPE.
One may need to implement timers or other logic scripts in the AAA to close these sessions. De-register the MS to have the new setting in affect The Ethernet port supports only Auto Negotiation mode.
Two service flows which have the same priority are equalized by the CPE at packet rates and not bit rates the packet sizes are not breezemxa into account. Known Issues and Limitations With Release 1. Update the desired Multiple Service Flows with the new service interface you have created.
When the sum of all provisioned services exceeds the CPE license capacity, the NE process will not be completed.
CS to ensure management of the bridged BTS b. The situation is auto recoverable and service is restored after few seconds.
Rocket M5 vs Alvarion BreezeMAX Extreme – Ubiquiti Networks Community
It’s a community-based project which helps to repair anything. Under GPS chaining, when there is a faulty chaining cable, the radio units in the chain may not initiate transmission. It is important to design carefully the frequency allocations and potential bands e. This service profile aims to optimize the air link performance attuned to the video content optimized for MPEG Any service modification requires MS de-registration in order to take place.
When using forwarding with option 82, breezfmax the Service Group gateway is a Cisco router the following configuration must be add on breezemxa Cisco to permit the DHCP packets to pass: Due to FCC regulation requirements, starting with release 1. The CPE will provision the services according to the order in which they are received until the license is exceeded.
After link with BTS is established, the new version is Set as main automatically by the device When deploying a multi sector site it is recommended using a single high profile GPS antenna kit along with GPS chaining cable CAT5e cable between the base-station on the same site.
When performing backhauling over Extreme CPE i. Recommended workaround is to minimize GPS holdover events — improving antenna installation location insure clear skyuse high gain profile antenna